Metal furring channel installation guide

Metal furring channel is a new type of building material that is widely used in hotels, stations, office buildings, amusement parks, interior decoration, and more. So, below, the editor will share with you how to install Metal Furring channel and what to pay attention to when installing Metal Furring channel ceiling?

1）.Metal furring channel installation
Installation steps for Metal furring channel:
1. The first step is to install the suspension rod.
2. Install the edge keel properly: The installation of the edge keel needs to be marked according to the design requirements, and then fixed with screws.
3. Install the main keel: Hang the main keel on the suspension rod and level it after hanging.
4. Installation of secondary keel: Install tightly against the main keel, with a spacing of generally 30-60cm.
5. Correct the skeleton of the Metal furring channel.
6. Installation of gypsum decorative board: It should be overlapped within the framework frame of the keel assembly.

2、 What to pay attention to when installing Metal Furring Channel ceiling
1. Site preparation
After the construction of the exterior walls of the building is completed, the pipelines inside the floors are completed, and there is no residual cement at the installation location. The site is clean and tidy, and gypsum board installation can be carried out. During joint construction, the temperature should be above 5 degrees Celsius and below 35 degrees Celsius, otherwise construction is prohibited.
2. Check materials
Confirm the type, specifications, and quantity of materials before installation. Gypsum board should be dry and flat. If it is affected by moisture, bent or deformed, the board should break, or the surface paper should bulge, it cannot be used. The metal furring channel must be flat, smooth, without rust or deformation. The sealant should be dry, free from moisture, and free from hardening.

3）. Suspension rod
The distance between the suspension rod and the surrounding walls is not more than 300mm; The distance between the suspension rod is not more than 1200mm, and it is recommended to use 1000mm; The top of the suspension rod must be securely fixed without any looseness, and the depth of the suspension rod must be consistent to ensure that the length of the suspension rod is the same.
4）. Carrying keel
The distance near the wall is not more than 300mm, and the spacing between load-bearing keels is not more than 1200mm. The load-bearing keels should be on the same horizontal line and adjusted and fixed by pulling through the line.

Article summary: The above is the relevant content shared by the editor on how to install Metal Furring Channel and what to pay attention to when installing Metal Furring Channel ceiling. We hope it can be helpful to everyone. Get prior knowledge of Metal furring channel installation to ensure smooth installation of your home ceiling.